| 1. The New Battery Isn't Charging. Is it defective battery ?
New laptop batteries or other batteries are shipped in a discharged condition or with very low capacity and must charged before use. We generally recommend an overnight charge (approximately twelve hours). Refer to the user's manual for charging instructions. Rechargeable batteries should be cycled (fully charged and then fully discharged) three to five times initially to allow them to reach their full capacity. (Note: it is normal for a battery to become warm to the touch during charging and discharging).
ASUS R1 Series Tablet PC Laptop Battery
Li-ion, 4400mAh, 11.1V
Today's Price: $47.59
Note:
New batteries are hard for the device to charge; they have never been fully charged and are therefore "unformed". Sometimes the device's charger will stop charging a new battery before it is fully charged. If this happens, remove the battery from the device and then reinsert it. The charge cycle should begin again. This may happen several times during the first battery charge. Don't worry; it's perfectly normal.
2. How to discharge and charge laptop battery ?
A typical charge and discharge cycle is as follow:
1. Install your newly purchased battery into your laptop Computer
2. Disconnect the laptop AC power adapter and use your laptop until it itself shuts down. In this situation, the battery is fully discharged.
3. Connect the laptop AC adapter and your battery should start charging.
4. Charge until the battery is full.
Repeat this charge and discharge cycle a few times and your battery pack will be conditioned to perform at full capacity.
Note: Please do not overdischarge and overcharge your battery.
3. How to discharge and charge digital camera battery ?
 SAMSUNG SLB-0737 battery charger Today's Price: $12.29
 SONY Cyber-shot DSC-W230 Camera Battery Today's Price: $23.99
(1).Place the battery in your digital camera until it itself turns off. In this situation ,the battery is fully discharged.
(2).Take out your battery and slide it into your battery charger.
(3). Connect your charger with power to fully charge the battery. It is normal for a new replacement battery that battery indicator shows 100% capacity in 10 to 15 minutes. Please keep charging until there are no time left for charging.
(4). Fully charged and fully discharged or "cycled" as much as five times to condition them into performing at full capacity.
Note: Our battery can not be charged with your camera directly. Please charge the battery with our battery charger .
4. If your battery can not charge with our battery charger, what is matter with the charger?
I think there is some electrical contact problem in your charger and you can fix it yourself in a few minutes.
(1). Remove your charger from the DC adapter.
(2). There are two hooks at the bottom of the charger.
(3). Your can release the top charging plate by pushing the hooks with two fingers.
(4). The top charging plate will release from the top.
(5). At the bottom of the charging plate, there will be three metallic contacts.
(6). Try pulling all the contacts so that it will avoid the bad connection.
(7). Slowly re-insert the charging plate to the charging base.
(8). Re-connect the DC adapter and your charger should work.
Good luck and if there is still other problem, please don't hesitate to send us a mail again.
SONY VAIO VGN-TT11M Laptop AC Power Adapter
Output : 16V
Output Current : 3.75A
Today's Price: $20.19
5. What does the light indicator mean when charging battery ?
(1).Plug the AC power adapter in a wall outlet.
(2). Connect the AC Power adaptor supplied with charger to the DC in jack.
(3). "Status" indicator shows RED when the charger is ready and "Charger" indicator shows flashing Green when waiting for battery pack.
(4). Slide battery pack in the charger and "Charger" indicator goes RED when charging.
(5). "Charger" indicator show RED and GREEN alternatively when battery pack has more than 90% charged.
(6).When the battery pack is fully charged, the "Charger" indicator shows a steady green.
(7). After the battery pack fully charged, slide the battery pack out.
(8). Unplug DC power, "CHARGE" and "STATUS" indicators go out. |
